LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Front Suspension & Wheel Alignment >> Front >> Knuckle, Steering, RWD >> Installation

Knuckle, Steering, RWD: Installation

NOTE:

Installation process is the same for both sides of the vehicle.

  1. Install the knuckle onto the lower ball joint. Refer to BALL JOINT, SUSPENSION, LOWER, INSTALLATION .
  2. Install the tension strut onto the knuckle. Refer to STRUT, TENSION, INSTALLATION .
  3. Install the upper ball joint onto the knuckle. Refer to ARM, UPPER CONTROL, INSTALLATION .
  4. Install the outer tie rod end to the knuckle. Refer to TIE ROD, STEERING, INSTALLATION .
  5. Install brake rotor. Refer to ROTOR, BRAKE, INSTALLATION .
    GC0170355Courtesy of CHRYSLER GROUP, LLC
  6. Install the front brake hose support bracket and bolt (1).
  7. Install the wheel speed sensor. Refer to SENSOR, WHEEL SPEED, FRONT, INSTALLATION .
  8. Install the tire and wheel assembly. Refer to INSTALLATION .
  9. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals