Front Toe
CAUTION:
Do not twist the inner tie rod-to-steering gear boots during front wheel Toe adjustment. Remove the boot clamps (2) at the inner tie rods and make sure the boots move freely on the inner tie rods.
NOTE:
Perform the following procedure to each side of the vehicle as necessary.
- Loosen the jam nut (3) at the inner-to-outer tie rod (4-5) connection.
- Grasp the inner tie rod at the hex and rotate as necessary to adjust front toe to the preferred toe specification. Refer to WHEEL ALIGNMENT, TECHNICAL SPECIFICATIONS .
- Tighten the tie rod jam nut (3) to the proper torque specifications, using care not to lose adjustment. Refer to TECHNICAL SPECIFICATIONS .
- Make sure the inner tie rod-to-steering gear boot is not twisted, then reinstall the boot clamp at the inner tie rod.
- Adjust front toe on opposite side of vehicle using the above procedure as necessary.
