Rear (Except SRT8)
NOTE:
Installation process is the same for both sides of the vehicle.
- If removed, install the abutment shims (1) onto the brake caliper adapter bracket.
- If equipped, remove the film from the brake pad double sticky isolator.
- Install the brake pads (2) onto the brake caliper adapter bracket.
- If police package equipped, install the clip on shims.
- Completely retract the caliper piston back into the bore of the caliper. Use a C-clamp to retract the piston. Place a wood block over the piston before installing the C-clamp to avoid damaging the piston.NOTE:
Use care when installing the caliper onto the adapter bracket to avoid damaging the guide pin boot.
- Install the brake caliper (3) onto the front brake caliper adapter bracket (1).
- Install the brake caliper guide pin bolts (5) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install the tire and wheel assembly. Refer to INSTALLATION .
- Remove the support and lower the vehicle.
- Pump brake pedal several times to set pads to caliper and brake rotor.CAUTION:
When NEW brake pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during the first brake applications following installation.
- Check and adjust brake fluid level in reservoir.
- Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake shoes.
