Diagnostic Test

VERIFY THE DTC IS ACTIVE
NOTE:
This DTC must be active for the results of this test to be valid.
1. Turn the ignition on.
2. With the scan tool, read and record the DTCs.
3. With the scan tool, read and record the Environmental Data to help identify the conditions in which the DTC was set.
4. With the scan tool, erase the DTCs.
5. Start the engine.
6. With the scan tool, read and record the DTCs.
  Is the DTC active at this time?
  
  Yes
  - Go To 2
  No
  - Perform the ABS-INTERMITTENT CONDITION TEST. Refer to ABS INTERMITTENT CONDITION .
(Z802) GROUND CIRCUIT OPEN OR HIGH RESISTANCE
NOTE:
The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.
1. Using a 12-volt test light connected to 12-volts, check the (Z802) Ground circuit.
  Does the test light illuminate brightly?
  
  Yes
  - Go To 3
  No
  - Repair the (Z802) Ground circuit for an open circuit or high resistance.
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
ANTI-LOCK BRAKE SYSTEM (ABS) MODULE
1. Turn the ignition off.
2. Inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires.
3. Inspect the related wire harness connectors. Look for broken, bent, pushed out, or corroded terminals.
4. Perform any Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
  No
  
  NOTE:
  For this failure it is necessary to replace both the ABS Module and the HCU as a complete unit.
  - Replace the Integrated Control Unit (ICU) in accordance with the Service Information. Refer to INTEGRATED CONTROL UNIT (ICU), REMOVAL .
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .