Glass, Door: Removal
- Raise the rear door glass up to it's full position.
- Remove the trim panel from the inside of the rear door. Refer to PANEL, REAR DOOR TRIM, REMOVAL .
- Remove the inner belt weatherstrip from the rear door.
- Carefully remove the closeout plug (1) covering the front window regulator access hole.
- Temporarily install the window switch pod, reconnect the negative battery cable and lower the window until the white regulator tab is visible in the access hole (1).NOTE:
Typical glass shown in illustration, Charger is similar.
- Using a small round bladed tool (2) or equivalent, release the door glass (1) from the window regulator glass sliders (3).
- Secure the window glass into place with a wedge or tape.
- Remove the door carrier plate. Refer to PLATE, CARRIER, REMOVAL .
- Remove the tape securing the glass, lower and remove the glass through the carrier plate cavity.
