Console, Floor: Installation
- Connect the electrical connectors (1) under the floor console.
- Align the floor duct at the rear of the floor console. Slide the floor console forward to the instrument panel.
- Open the floor console lid and install the four bolts (1) that secure the floor console to the floor and tighten securely.
- Install the mat bin and the coin holder bin.
- Install the two screws (1) and tighten securely.
- Position the manual park release (4) and install the two screws (3), if equipped. Tighten the screws securely.
- Snap the manual park brake cable (5) into the retainer.
- Connect the wire harness connector (2).
- Align the floor console side close out panels (1) to the floor console and use hand pressure to engage the retaining clips.
- Align the storage bin (1) and push in to engage the two retaining clips.
- Install the screws (2) and tighten securely.
- Position the shifter bezel (1) and use hand pressure to engage the retaining tabs.
- Install the shifter knob (2) and install the screw (4). Tighten the screw securely.
- Connect the wire harness connector (3).
- Position the shifter boot (1) and engage the retaining clips.
- Connect the negative battery cable.
