Door, Rear: Adjustments: In/Out

Courtesy of CHRYSLER GROUP, LLC

NOTE:

In/out door adjustment is done by loosening the hinge to door fasteners one hinge at a time and moving the door to the correct position.

Support the rear door with a suitable lifting device.
Loosen the two bolts (2) that secure the striker (1) to the C-pillar.

Courtesy of CHRYSLER GROUP, LLC
Loosen the nuts (2 and 3) that secure the door hinges (1 and 5) to the rear door (4).
Adjust the rear door to the correct position. Refer to GAP AND FLUSH, SPECIFICATIONS .
Tighten the nuts (2 and 3) that secure the door hinges (1 and 5) to the rear door (4) to the proper torque specifications using the following sequence. Refer to TORQUE SPECIFICATIONS .
1. Tighten the upper nut on the upper hinge (1).
2. Tighten the lower nut on the lower hinge (4)
3. Tighten the remaining hinge nuts.
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Make sure the protrusion (3) is orientated towards the interior of the vehicle.
Tighten the two bolts (2) that secure the striker to the C-pillar to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .