LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Body & Frame >> Seats >> Body - Interior & Exterior >> Seats, Rear >> Cover, Seat Back, Rear >> Installation >> 40% Seat Back

40% Seat Back

GC0170657Courtesy of CHRYSLER GROUP, LLC
NOTE:

There is a hole (5) in the foam next to each molded clip (6) to aid in clip strip installation.

  1. Position the seat back cover (2) onto the seat back foam (3), starting at the top, and fasten the hook loop fasteners (4).
  2. Align the clip strips (1) to the molded clips.
    NOTE:

    Note that there is a hole in the foam, next to each molded clip, to aid in clip strip alignment/installation.

    GC0162420Courtesy of CHRYSLER GROUP, LLC
  3. Press the clip strip (2) into each molded clip (1).
    GC0170690Courtesy of CHRYSLER GROUP, LLC
  4. Position the seat back assembly (1) onto the seat back frame (4) and install the push fastener (2).
  5. Route the seat back latch strap through the sleeve in the seat back cover.
    GC0170783Courtesy of CHRYSLER GROUP, LLC
  6. Install the pivot bushing (1).
    GC0170636Courtesy of CHRYSLER GROUP, LLC
  7. Fasten the retainer strip (1) at the bottom of the seat back cover (2).
  8. Close the zippers (3) on both sides of the seat back and tuck the zipper up into the seat back cover.
  9. Install the rear seat back into the vehicle. Refer to SEAT BACK, REAR, INSTALLATION .
scientia non olet · About LEMON Manuals