Seat, Front: Installation
WARNING:
Handled seats carefully when servicing. Be careful not to drop seats on the workbench or floor. If dropped, the seat position sensor may become damaged and inoperative. Failure to follow these instructions may result in serious or fatal injury.
- Before proceeding with the following repair procedure, review all warnings and cautions. Refer to SEATS, FRONT, WARNING .
- Position the front seat into the vehicle.CAUTION:
Do not use the adjuster release bar as a handle when removing or installing the front seat.
- Connect all wire harness connectors.
- Install the two front bolts (2) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Connect the negative battery cable.
- Move the front seat (1) to the full forward position.
- Install the two rear bolts (2) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install the lower seat belt anchor (3) and bolt (2) then tighten the bolt to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Install the trim cover (1).
- Perform the supplemental restraint system verification test. Refer to SUPPLEMENTAL RESTRAINT SYSTEM VERIFICATION TEST .
