Without Sunroof

NOTE:

In the event the headliner is damaged or creased during installation, it will need to be replaced with a new headliner.

Use clean gloves or make sure your hands are clean before removing the headliner.

Courtesy of CHRYSLER GROUP, LLC

Carefully insert the headliner through the windshield opening.
With the help of an assistant, position the headliner (3) into the vehicle.
Connect the visor wire harness connectors and let the visors hang until the front of the headliner is fastened.
Raise the headliner and engage the retaining clips and push fasteners near the center.
Engage the retaining clips (2) and push fasteners (1) at the rear.

Courtesy of CHRYSLER GROUP, LLC
Install the visors and the two screws (2). Tighten the screws securely and install the screw cover (1).

Courtesy of CHRYSLER GROUP, LLC
Install the screw (1) behind the overhead console and tighten securely.

Courtesy of CHRYSLER GROUP, LLC
Route the headliner harness (2) and connect the electrical connector (1) at the A-pillar.
Position the visor support and install the screw. Tighten the screw securely.
Install the overhead console. Refer to CONSOLE, OVERHEAD, INSTALLATION .
Position the grab handles and install the screws. Tighten the screws securely then install the screw covers.
Install the upper C-pillar trim panels. Refer to PANEL, C-PILLAR TRIM, INSTALLATION .
Install the B-pillar trim panels. Refer to PANEL, B-PILLAR TRIM, INSTALLATION .
Install the A-pillar trim panels. Refer to PANEL, A-PILLAR TRIM, INSTALLATION .
If removed, install the windshield. Refer to WINDSHIELD, INSTALLATION .
Connect the negative battery cable.