LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Tires & Wheels (Service Information) >> Tire Pressure Monitoring >> Sensor, Tire Pressure Monitoring (TPM) >> Removal >> Non SRT8

Non SRT8

  1. Raise and support vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove tire and wheel assembly.
    CAUTION:

    The cap used on this valve stem contains an O-ring seal to prevent contamination and moisture from entering the valve stem. Do not substitute a regular valve stem cap in its place.

    GC0088908Courtesy of CHRYSLER GROUP, LLC
  3. Dismount tire from wheel following tire changer manufacturers instructions while paying special attention to the following to avoid damaging the pressure sensor:
    1. When breaking the tire bead loose from the wheel rim, avoid using the Bead Breaker in the area of the sensor (1). That includes both outer and inner beads of the tire.
    2. When preparing to dismount the tire from the wheel, carefully insert the mounting/dismounting tool 280° from the valve stem ± 10°, then proceed to dismount the tire from the wheel. Use this process on both outer and inner tire beads.
    GC0137043Courtesy of CHRYSLER GROUP, LLC
  4. Remove the sensor to valve stem retainer screw (3) and remove the sensor (1) from the valve stem (2).
  5. Remove the valve stem (2) from the wheel (4).
scientia non olet · About LEMON Manuals