Mirror, Outside Rearview, Glass: Removal: Glass
WARNING:
Always wear eye and hand protection when servicing the mirror glass. Failure to observe these warnings may result in personal injury from broken glass.
- Push mirror glass case (2) into full down position
- Disconnect and isolate the negative battery cable.
- Place thumbs behind mirror glass case (2) and push out from the mirror assembly (1). This will disengage the mirror glass case's snap attachment feature.
- If equipped, disconnect the blind spot indicator and heater wires (1) by pulling on thumb tabs.
- Disconnect the mirror motor glass electrical connector (2).
- Remove the mirror glass case (1) from the glass motor by pulling up and out. This will disengage the "hook" feature at the bottom of the mirror glass case assembly (1).
