Sensor Circuit Test

Refer to the appropriate wiring information for complete circuit schematic or connector pin-out information.

1. Transition the ignition switch to the OFF status. Disconnect and isolate the battery negative cable. Disconnect the wire harness connectors from the ambient temperature sensor and the BCM.
2. Connect a jumper wire between the two terminals in the body half of the ambient temperature sensor harness connector.
3. Check for continuity between the sensor return circuit and the ambient temperature sensor signal circuit cavities of the BCM harness connector. There should be continuity. If OK, go to Step 4. If not OK, repair the open sensor return circuit or ambient temperature sensor signal circuit to the ambient temperature sensor as required.
4. Check for continuity between the ambient temperature sensor signal circuit cavity of the BCM harness connector and a good ground. There should be no continuity. If OK, test the EVIC operation. Refer to CENTER, ELECTRONIC VEHICLE INFORMATION, OPERATION . If not OK, repair the shorted ambient temperature sensor signal circuit as required.