With Sunroof
NOTE:
In the event the headliner is damaged or creased during installation, it will need to be replaced with a new headliner.
Use clean gloves or make sure your hands are clean before removing the headliner.
- Carefully insert the headliner through the windshield opening.
- With the help of an assistant, position the headliner (1) into the vehicle and connect the sunroof wire harness connector (2).
- Connect the visor wire harness connectors and let the visors hang until the front of the headliner is fastened.
- Raise the headliner (2) and engage the hook and loop fasteners (1) around the sunroof opening.
- Engage the retaining clips (2) and push fasteners (1) at the rear.
- Install the visors and the two screws (2). Tighten the screws securely and install the screw cover (1).
- Install the screw (1) behind the overhead console and tighten securely.
- Route the headliner harness (2) and connect the electrical connector (1) at the A-pillar.
- Position the visor support and install the screw. Tighten the screw securely.
- Install the overhead console. Refer to CONSOLE, OVERHEAD, INSTALLATION .
- Position the grab handles and install the screws. Tighten the screws securely then install the screw covers.
- Install the upper C-pillar trim panels. Refer to PANEL, C-PILLAR TRIM, INSTALLATION .
- Install the B-pillar trim panels. Refer to PANEL, B-PILLAR TRIM, INSTALLATION .
- Install the A-pillar trim panels. Refer to PANEL, A-PILLAR TRIM, INSTALLATION .
- If removed, install the windshield. Refer to WINDSHIELD, INSTALLATION .
- Connect the negative battery cable.
- Re-initialize the sunroof motor. Refer to MOTOR, SUNROOF, STANDARD PROCEDURE .
