LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lamps/Lighting - Exterior (Service Information) >> Sensor, Stop Lamp >> Installation

Sensor, Stop Lamp: Installation

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

GC0144749Courtesy of CHRYSLER GROUP, LLC
  1. Press and hold the brake pedal in the pressed position.
  2. Position the brake pedal position sensor (3) to the sensor bracket on the brake pedal support bracket (1).
  3. Engage the sensor locating pin into the locating hole in the sensor bracket.
  4. Install the screw (2) that secures the sensor to the sensor bracket. Tighten the screw securely.
  5. Release the brake pedal. Then pull the pedal lightly upward to be certain the pedal is in its normal at-rest position.
    GC0144748Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Be certain the brake pedal position sensor is fully seated in the sensor bracket before completing the electrical connection.

  6. Connect the body wire harness connector (3) to the connector receptacle on the sensor (2).
  7. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
  8. Connect the battery negative cable.
  9. Perform the "Brake Pedal Calibration" and the Brake Pedal Learn" procedures as follows:
    1. Park the vehicle on level ground.
      NOTE:

      When performing the Brake Pedal Calibration Learn routine, make sure the brake pedal is NOT  pressed.

      NOTE:

      Not all PCMs support the Brake Pedal Learn. If the PCM supports it the routine will be available.

    2. With the scan tool, under the ABS "Miscellaneous Functions" menu, select and run the "Brake Pedal Calibration" routine.
    3. With the scan tool, under the PCM "Miscellaneous Functions" menu, select and run the "Brake Pedal Learn" routine.
      NOTE:

      This routine is available for 2018 model year or newer models. In the event that the vehicle is a 2017 or older model, only the "Brake Pedal Calibration" routine will be available.

scientia non olet · About LEMON Manuals