LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> (Audio (Radio) - Electrical Diagnostics) >> DTC Troubleshooting >> B1408-1A-Rear Left Audio Speaker Output-Circuit Resistance Below Threshold - Base >> Diagnostic Test

Diagnostic Test

  1. CHECK FOR AN ACTIVE DTC 
    1. Turn the ignition on and open one of the front doors.
      NOTE:

      A front door must remain open whenever checking or erasing Radio DTCs.

    2. With the scan tool, read Radio DTCs and record on the repair order.
    3. Cycle the ignition from on to off, wait five seconds and then back to on.
    4. Turn the radio on and set the volume to 25.
    5. Adjust the speakers to the rear and center.
    6. With the scan tool, read Radio DTCs.

      Did the DTC return?

      Yes 

      • Go To  2

      No 

      • The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  2. CHECK THE LEFT REAR SPEAKERS 
    1. Make sure one of the front doors is still open.
    2. With the scan tool, erase the DTCs.
    3. Turn the ignition off.
    4. Disconnect the Left Rear Speaker harness connector.
    5. Turn the ignition on.
    6. Turn the radio on and set the volume to 25.
    7. With the scan tool, read the active Radio DTCs.

      Is the DTC active?

      Yes 

      • Go To  3

      No 

  3. CHECK THE (X303) LEFT REAR SPEAKER (+) CIRCUIT, AND THE (X393) LEFT REAR SPEAKER (-) CIRCUITS FOR A SHORT TOGETHER 
    1. Disconnect the Radio C1 harness connector.
    2. Check for continuity between the (X303) Left Rear Speaker (+) circuit and the (X393) Left Rear Speaker (-) circuit at the Radio C1 harness connector.

      Is there continuity between the (X303) Left Rear Speaker (+) circuit and the (X393) Left Rear Speaker (-) circuit?

      Yes 

      • Repair the (X303) Left Rear Speaker (+) circuit, and the (X393) Left Rear Speaker (-) circuit for a short together.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No