Diagnostic Test
- CHECK FOR AN ACTIVE DTC NOTE:
Verify the connection of the Inside Rearview Mirror harness connector.
- With the scan tool, read Radio DTCs and record on the repair order.
- With the scan tool, erase DTCs.
- With the scan tool, read Radio DTCs.
Did the DTC return?
Yes
- Go To 2
No
- The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- CHECK THE INSIDE REARVIEW MIRROR
- Turn the ignition off.
- Disconnect the Inside Rearview Mirror harness connector
- Connect a jumper wire between the (X722) Microphone 2 IN (+) and the (X723) Microphone 2 IN (-) circuits at the Rearview Mirror harness connector.
- Turn the ignition on.
- With the scan tool, read Radio DTCs.
Did the DTC return?
Yes
- Go To 3
No
- Replace the Inside Rearview Mirror in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- CHECK THE (X722) MICROPHONE 2 IN (+) CIRCUIT FOR AN OPEN
- Turn the ignition off.
- Disconnect the Radio harness C1 connector.
- Measure the resistance of the (X722) Microphone 2 IN (+) circuit between the Inside Rearview Mirror and Radio C1 harness connectors.
Is the resistance below 3.0 Ohms?
Yes
- Repair the (X722) Microphone 2 IN (+) circuit for an open.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 4
- CHECK THE (X723) MICROPHONE 2 IN (-) CIRCUIT FOR AN OPEN
- Measure the resistance of the (X723) Microphone 2 IN (-) circuit between the Inside Rearview Mirror and Radio C1 harness connectors.
Is the resistance below 3.0 Ohms?
Yes
- Repair the (X723) Microphone 2 IN (-) circuit for an open.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Replace the Radio in accordance to the service information. Refer to RADIO, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Measure the resistance of the (X723) Microphone 2 IN (-) circuit between the Inside Rearview Mirror and Radio C1 harness connectors.